Publicidad
Idiomas disponibles
Idiomas disponibles
English (BioKey Inside Fingerprint, with IR-Keypad for administration)
Technical specifications
Dimensions of external unit (WxHxD):
Fingerprint Sensor:
Operating voltage:
Relay specs:
Temperature range:
Storage capacity:
Function:
Infrared Keypad
Instructions:
1. If the cabling is correct at least the blue LED lights up continuously.
2. We recommend washing the hands before enrolling master/userfingers.
3. After each sequence of recording a finger (dragging a finger over the sensor) compulsorily wait for
a while (~3s) until the corresponding LED lights up to indicate that you can drag the next finger over
the sensor.
4. Userfingers are those fingers meant for opening the door. Masterfingers are those fingers by which
userfingers can be enrolled. In the delivery default condition (all 3 LEDs light up) the first 3
enrolled fingers are automatically the masterfingers. Masterfingers should never be enrolled
as userfingers.
5. Dragging the fingers over the sensor – Tips
• Drag your fingers uniformly and only with gentle pressure.
• Make sure to drag as much as possible a large area of the finger lines over the sensor cell (see
figure below).
6. Which finger should you use?
Fingertips with scars/injuries are
unsuitable as userfingers; use
therefore an alternative finger.
At least two fingers (each three
times) per person should be
enrolled. In case of an injury or
bandage on a finger use the "stand-by finger" freely. Totally, up to 150 fingers can be enrolled.
If the number of persons is small it is worthwhile to start with more fingers per person, because
most users tend to settle down to a preferred finger for identification only after a considerable time.
IDENCOM Germany GmbH, Schillerstr. 54~6-58, 10627 Berlin
Tel. +49-30-398839 310, Fax: Tel. +49-30-398839 318 E-mail:
IDENCOM Germany GmbH-February 13– Printed in Germany- All rights reserved
BioKey® is a registered trademark of IDENCOM AG (Schweiz). All other names are the property of there respective owners
44x75x29 mm
Swipe Sensor, >2 Mio. Using
8 ~ 24V DC
24 V DC / max. 500 mA
-20 ~ +85 Grad
up to 150 fingerprints
Single Finger Delete with
right
support@idencom.com
www.idencom.com
wrong
.
5/32
Publicidad
