Idencom ATMEL Manual Del Propietário página 8

5. Delete All (Reset): Current CODE
With the Infrared Keypad: DA -> CODE -> OK
-> After Reset, device is initialized; Red, Green and Blue LEDs are alight
Factory setting: xxxxxx (4~6-digits), to change the Code (very important):
D-> E-> OLD CODE -> OK-> NEW CODE (xxxxxx) -> OK
Tips: Alternative Option for Delete(Reset): : Swipe the Master finger three times over the sensor and
waiting for about 30 sec -> Device is initialized.
6. Set the security level
Read in a masterfinger
Press any of the H/M/L buttons, depending on your choice
Press OK to confirm
Button L: Low security (corresponds to 3-digit PIN-code security)
Button M: Medium security (corresponds to 4-digit PIN-code security)
Button H: High security (corresponds to 5-digit PIN-code security)
Red and green LEDs flash twice briefly to indicate that the setting is done.
The on delivery default security level is set to M. The security level can be reconfigured at any time.
7. Set the relay switching time
Read in a masterfinger
Press the RT button.
Press the R1 for Relay 1, R2 for Relay 2 or the buttons R1 and R2 consecutively for both relays.
Enter the digit(s) for the relay switching time in seconds (1 to 65 seconds)
Press OK to confirm.
In the default delivery condition the switching time for both relays is set to 3 seconds.
8. Block IDs (temporary users like guests)
Read in a masterfinger
Press the B button
Enter ID
Press OK to confirm
All fingerprints stored under the entered ID are now blocked and will be rejected.
Individual IDs can be temporarily blocked without having to lose the enrolled fingerprints. They can be unblocked again later, and
the person concerned need not be present to enroll his/her finger once again.
9. Unblock the IDs
Read in the masterfinger
Press the UB button.
Enter the ID.
Press OK to confirm.
All fingerprints of this ID are now unblocked again.
10. Blocked mode (Block/Unblock the terminal)
Blocking: If a finger that has not been enrolled is dragged consecutively for 5-times over the sensor
(red LED lights up), the module changes into blocked mode. This is to prevent unauthorized persons
from gaining entry through indefinite number of attempts over a period.
If the device is in blocked mode, this is indicated by the flashing red LED. The blocked mode is initially time-limited; in case of 5
more failed attempts the blocked mode gets extended correspondingly (Blocking intervals: 1 minute, 5 minutes, 30 minutes, 1
hour, thereafter continuous blocking)
Unblocking: The blocked mode can be prematurely terminated by dragging an enrolled finger (master
or userfinger) over the sensor twice directly consecutively.
11. Check ID (to check if a number/ID is allocated already)
Press the OK button.
Enter the ID to be checked
Press the OK button again.
If the ID has been allocated already, both LEDs (red and green) light up.
If the ID is not allocated, only the red LED lights up.
8/32