Publicidad
Idiomas disponibles
Idiomas disponibles
IV.
All functions in detail
1. Enroll masterfingers
(3 x masterfinger: 3-times the same or three different fingers)
The device must be initialized (red + green + blue LEDs light up continuously, otherwise see Reset.)
Swipe the first masterfinger over the sensor, blue LED flashes for approx. 3 secs; wait, red + green
LEDs go off briefly and light up again continuously.
Swipe Drag the second masterfinger over the sensor, blue LED flashes for approx. 3 secs; wait, red +
green LEDs go off briefly and light up again continuously.
Swipe Drag the third masterfinger over the sensor, blue LED flashes for approx. 3 secs; wait, green
LED lights up briefly on and off. When all 3 masterfingers are enrolled, the device will be ready for
operation (only the blue LED lights up). Now, userfingers can be enrolled.
If during the enrolling operation a finger has been dragged but not accepted as masterfinger, then, the red + green LEDs continue
to be on. In that case, repeat the operation to enroll the masterfinger. Timeout: 60 secs. Between each enrolling operation for
masterfingers do not wait for more than 60 secs; otherwise the enrolling operation must be repeated.
2. Enroll userfingers together with an ID number
Masterfingers must not be enrolled as userfingers.)
(
The enrolling mode for userfingers is activated by reading in a masterfinger.
Red and green LEDs flash briefly.
Press the
E
(Enrollment) button (below right) on the remote control.
Enter an
ID
between 1 and 150 over the remote control.
Press
OK
to confirm.
If the finger to be enrolled is to switch only one relay, press R1 for Relay 1 or R2 for Relay 2, before confirming with OK. If none
of the relay buttons are operated, then both relays are switched automatically.
Enrolling one or more userfingers (Swipe over the sensor, every Finger 3~6 times)
If the enrolling operation is successful the green LED lights up; if the quality is inadequate the red LED lights up. We recommend enrolling
individual userfingers 3-times in order to optimize the rate of recognition. All fingers will be stored under the entered ID.
The enrolling operation is completed by reading in a masterfinger once again.
Red and green LEDs light up briefly; it is possible to store several persons under one ID. But be forewarned that in the delete
mode all those fingerprints will be deleted which are stored under a single ID.
If the enrolling operation is not completed within 10 secs after the last enrollment of a finger, the operation will be canceled
without storing the previously enrolled fingers.
3. Identification
Swipe a userfinger over the sensor.
The green LED lights up if the finger is identified and the relay is switched on. The red LED lights up if the finger is not identified.
4. Delete individual userfingers
The delete mode for userfingers is activated by reading in a masterfinger.
Red and green LEDs flash briefly.
Press the
D
Green LED flashes.
Enter the
ID
Press
OK
to confirm.
Green LED flashes.
The delete operation is completed by reading in a masterfinger once again.
Red and green LEDs flash briefly.
(Delete) button (below left) on the remote control.
of the userfinger to be deleted.
7/32
Publicidad
