Troubleshooting - Silverline 267213 Traducción Del Manual Original

GB
NOTE: Make sure the shaft has completely engaged into a locating notch
prior to use.
Power supply
• Use of an RCD (residual current device) will reduce the chance of electric
shock when using an outdoor power tool
• If it is necessary to use an extension lead, check that the lead is
specifically intended for outdoor use
Switching on and off
1. Ensure the trimmer head is in the correct position
2. Place the trimmer down and connect the mains power supply
3. Pick up the trimmer; hold the machine with one hand on the Handle
(5) and the other on the Adjustable Secondary Handle (3). The handle is
equipped with an integrated Safety Switch (8)
4. To switch on the machine, squeeze the Safety Switch (8), and then
the On/Off Switch (4). The machine will run until the on/off switch is
released
Function change
1. Ensure that the trimmer is unplugged from its power source
2. Press and hold the Function Change Button (1), and rotate the end of
the trimmer
3. When the trimmer has successfully located, release the function change
button. Check the head is secure by attempting to rotate the head
without using the function change button. The head should not move
Cutting
1. Always keep the machine at arms length, with the trimmer head
pointed away from your body
2. Move the trimmer head across the area to be trimmed using a smooth
sweeping motion
3. When approaching an edge or wall, use the roller guide to prevent
cutting or damaging other surfaces in the garden
4. Always be aware of the position of the power cord. Keep the power cord
well away from the cutting area at all times
Feeding the trimmer line
1. Switch the trimmer on
2. 'Bump' the Spool Housing (9) gently against the ground and the spool
will release trimmer line
3. The guard has a cutting edge which will cut off any excess line released
by the spool
Accessories
• A range of accessories and consumables are available from your
Silverline stockist. Spare parts can be obtained from toolsparesonline.
com
Maintenance
WARNING: ALWAYS disconnect from the power supply before carrying out
any inspection, maintenance or cleaning.

Troubleshooting

Problem
No function when On/Off
Switch (4) is operated
Bad quality cut
6
Possible cause
No power
Defective On/Off Trigger Switch
Grass is too high or too thick for the trimmer motor
Vegetation is wrapped around the cutting head
General inspection
• Check regularly that all the fixing screws are tight
• Inspect the supply cord of the tool, prior to each use, for damage or wear.
Repairs should be carried out by an authorised Silverline service centre.
This advice also applies to extension cords used with this tool
Spool maintenance
• After every use, ensure that all waste material is removed from the spool
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to
wear quickly, and will shorten the machine's service life. Clean the body
of your machine with a soft brush, or dry cloth. If available, use clean, dry,
compressed air to blow through the ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do
not use alcohol, petrol or strong cleaning agents
• Never use caustic agents to clean plastic parts
Lubrication
• Slightly lubricate all moving parts at regular intervals with a suitable
spray lubricant
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
prior to use.
Disposal
Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools
Solution
Check power supply
Replace the On/Off Switch at an authorised Silverline service centre
Focus on less concentrated areas of grass
Switch off the trimmer and clear vegetation from the cutting head area