KENMORE ELITE 89308-D Manual De Uso Y Cuidado página 5

TO ATTACH FLATBEATER, W IRE WHIP OR DOUGH HOOK
1. Turn Speed Control Knob to OFF.
2. Unplug Stand Mixer or disconnect power.
3. Place Bowl Lift Handle in down position.
4. Align slot at the top of Beater!Attachment with pin
on Mixer Head's shaft. Push Beater!Attachment up
onto shaft and turn counterclockwise until pin moves
all the way into the slot (see Fig. 6 and6A).
5. Before using Mixer, be sure to place Bowl Lift
Handle in the up position.
TO REMOVE FLAT BEATER, WIRE WHIP
OR DOUGH HOOK
1. Turn Speed Control Knob to OFF.
2. Unplug Stand Mixer or disconnect power.
3. Place Bowl Lift Handle in down position.
4. Turn Beater!Attachment clockwise on shaft until pin
on shaft lines up with slot on attachment. Pull down
and off.
TO REMOVE BOWLS FROM MIXER
.
2.
3.
4.
5. Remove Bowl.
Turn Speed Control Knob to OFF.
Unplug Stand Mixer or disconnect power.
Place Bowl Lift Handle in down position.
Pull up on Bowl Supports and lift Bowl off of Locating Pins.
TO ATTACH SPLASH GUARD
Another feature of this Mixer is the Splash
Guard_ which helps keep ingredients from
splashing out of the bowl while Mixer is on.
The Guard fits over the rim of either Bowl.
The Splash Guard also has a funnel area
for adding ingredients while the Mixer is on.
Attach Splash Guard after Bowl and Beater,
Whip or Hook have been attached. The open
part of the Splash Guard faces the Mixer,
with the funnel on the right as you face the
Mixer (Fig. 7). Rest the Splash Guard on
the rim of the Bowl with the plastic tabs on
the outside of the Bowl (Fig.7A).
m
_ ii!i ¸