KENMORE ELITE 89308-D Manual De Uso Y Cuidado página 7

USING THE COUNT-UP TIMER MODE
Fig. 9
The Count-Up Timer Mode can be especially useful to record I _ -I
mixing time. When the recipe does not specify a specific mixing _ _ _
J
time, you can monitor the time it takes to thoroughly mix the I
ingredients, so the next time you mix the same ingredients you ,__n J _
T_
can set the Count-down Timer for the specific time. The Count-up [ / _/
timer automatically begins counting as soon as the Speed
L /
Control Knob is turned on. When you turn the Mixer back to OFF, the Counter resets
to zero. At any time you can press the Timer Set / Pause Button and the Mixer will
enter Count-down Timer Mode.
USING THE PAUSE MODE
While the Mixer is running, you can push the Timer Set / Pause Button once and it
will pause the Mixer. The time elapsed will flash in the LCD Display. With this feature
you can assess the mixing process or add additional ingredients without affecting the
timer. To resume mixing, lust push the button again and the Timer will resume from
where it stopped, if you want, you can reset the Timer at this point by turning Speed
THE TIMER SET / PAUSE BUTTON
Another way to cancel out the time on the Timer is to press and hold down on the
Timer Set / Pause button until the LCD Display shows all zeroes.
THE PULSE FEATURE
A special feature of this Mixer is the Pulse Mode. Sometimes it
is necessar to be able to stir in ingredients very slowly and
gradually. The Pulse Mode is perfect for this. To use the Pulse
Mode, put the Speed Control Knob on 1. This is the only speed
in which the Pulse Mode will work. While on setting 1(Pulse), press in on the center of
theSpeed Control Knob. This is the Pulse button. Each time you push the button, the
Beater/Attachment will revolve about 2 times and stop.
When you have finished with the Pulse Mode, turn the Speed Control Knob back to
OFF. If the Mixer stays in the pulse mode for too long without being used, a message
of E3 will flash in the LCD Display. Turn the Speed Control Knob to OFF and the
message will clear.
WORK LIGHT AND POWER INDICATOR LIGHT
When the Mixer is pDgged in and turned ON, a blue LED Light encircling the
Speed Knob comes on. A Work Light also comes on to iIDminate the work area
above the bowl.
When you turn the Mixer OFF, the blue LED Light around the Speed Knob goes out.
The Work Light stays on for 3 minutes, then shuts off.
NOTE: LCD Display stays on whenever the Stand Mixer is Plugged in.