Allen-Bradley FORCE 1336 Instrucción página 2

2 1336 FORCEt Language Module Replacement
3. Remove the module by squeezing the
sides - in, and pulling outward. Discard
module.
4. Position the new Language Module on
the board, using the silk screen outline on
the board as a guide.
5. Carefully align the module connector
with the board connector. Firmly press the
module onto the board until fully seated.
The module will "snap" (lock) in place.
6. Replace drive cover and check for proper
operation.
Important: Each module contains English
and an alternate language. The
factory default setting for the
[Language] parameter is
"English." To program and
operate the drive in the alternate
language, the [Language]
parameter must be programmed
to the alternate language.
1336 FORCE is a trademark of Allen-Bradley Company, Inc.