Connecting The Water Supply - Crosley CB22G6Q Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation,
Connecting the
water supply
(For units with optional ice maker)
WARNING
To reduce the risk of injury or
death, follow basic precautions,
including the following:
Read
all
instructions
installing device.
• DO NOT attempt installation if
instructions are not understood or
if they are beyond personal skill
level.
• Observe all local codes and ordi-
nances.
• DO NOT service device unless
specifically
recommended
Owner's Manual or published
user-repair instructions.
• Disconnect power to unit prior to
installing device.
CAUTION
To avoid property damage or possi-
ble injury, follow basic precautions,
including the following:
Consult a plumber to connect cop-
per tubing to household plumbing
to assure compliance with local
codes and ordinances.
Confirm water pressure to water
valve is between 20 and 100 PSI. If
water filter is installed, water pres-
sure to water valve must be a min-
imum of 35 PSI.
DO NOT use a self-piercing, or
saddle valve. Both reduce water
flow, become clogged with time,
and may cause leaks if repair is
attempted.
Tighten nuts by hand to prevent
cross threading. Finish tightening
nuts with pliers and wrenches. DO
NOT overtighten.
Wait 24 hours before placing unit
into final position to check and cor-
rect any water leaks.
5
cont.
MATERIALS NEEDED:
1
" outer diameter flexible copper
4
tubing
• Shut-off valve requires a
drilled into water supply before valve
attachment
• Adjustable wrench
1
" hex nut driver
4
NOTE: Add 8' (2,4 m) to tubing length
before
needed to reach water supply for creation
of service loop.
Create service loop with tubing using
care to avoid kinks in tubing.
in
Remove plastic cap from water valve
inlet port.
Place brass nut and sleeve on copper
tube end as illustrated.
3
"
16
Place end of copper tubing into water
valve inlet port. Shape tubing slightly –
DO NOT KINK – so that tubing feeds
straight into inlet port.
1
" hole to be
4
Inlet
Plastic
Cap
Port
Brass
Nut Sleeve
Slide brass nut over
sleeve and screw nut
into inlet port. Tighten
nut with wrench. Pull on
tubing to confirm con-
nection is secure.
IMPORTANT: DO NOT overtighten.
Cross threading may occur.
Locate water tubing
clamp and install with
1
" hex head screw.
4
Turn on water supply
and check for leaks and
correct, if present.
Monitor water connection for 24
hours. Correct leaks, if necessary.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cb22g6w

Tabla de contenido