Preparation For Training - Ambu AmbuMan I Manual Del Usuario

An overview of the different LED status can be seen in the following table:
LED status
Green steady
Green slow flashing
Green fast flashing
Off
4.2.3 Reset to default settings (only AmbuMan W)
To reset the manikin into the default settings press the power button for more than 10
seconds. The manikin will reboot with the default settings.
Detailed information about the default settings can be found in the Directions for use
for the Ambu CPR-Software.

5. Preparation for training

The manikin is normally supplied in a special carry bag which, when opened, folds out to
provide a mat for the trainee during training.
When supplying as a full body model, the legs will be in a separate carry bag.
5.1. Carry bag/training mat ③
Unfold the bag. Make sure that the manikin is firmly secured to the training mat by
inserting the fitting on the training mat into the recess high up on the back of
the manikin.
5.2. Mounting the legs on the torso ④
Pull down the trousers a little around the hips. Place the legs in a position so that the 2
dowels on the hip part can slide into the corresponding dents at the bottom of the
manikin's body, see 4.1.
5.3. Mounting the head bag and face piece ⑤
Unfold the head bag and hold as shown, see 5.1.
Holding the ring of the bag, fold together as shown on the photos, see 5.2 and 5.3.
Insert bag in the head, see 5.4.
8
492 2340 40 vers 1_0_0_text.indd 8
LED Description
System running

System booting

System running and

low battery
System off

Flashing pattern
0 1 2 3 4 5 6 7
0 1 2 3 4 5 6 7
Seconds
0 1 2 3 4 5 6 7 0 1 2 3 4 5 6 7
Seconds
Seconds
Seconds
0 1 2 3 4 5 6 7
0 1 2 3 4 5 6 7
0 1 2 3 4 5 6 7 Seconds
0 1 2 3 4 5 6 7
Seconds
Seconds Seconds
0 1 2 3 4 5 6 7
0 1 2 3 4 5 6 7
Seconds
0 1 2 3 4 5 6 7 0 1 2 3 4 5 6 7
Seconds
Seconds Seconds
0 1 2 3 4 5 6 7
0 1 2 3 4 5 6 7
0 1 2 3 4 5 6 7 Seconds
0 1 2 3 4 5 6 7
Seconds
Seconds Seconds
8/18/2009 1:33:00 PM