For Your Safety - Kettler ERGORACE Instrucción De Montaje

english
Assembly Instructions
Before assembling or using the exercise cycle , please read the following instructions carefully. They contain important
information for use and maintenance of the equipment as well as for your personal safety. Keep these instructions in a
safe place for maintenance purposes or for ordering spare parts.

For Your Safety

RISK!
! Instruct people using the equipment (in particular children)
on possible sources of danger during exercising.
RISK!
! While assembly of the product keep off children's reach
(Choking hazard - contains small parts).
RISK!
Heart rate monitoring systems can be imprecise. Excessive
!
training may lead to serious health damage or death. If you feel
giddy or weak, please stop the training immediately.
WARNING!
! The training device should be used only for its
intended purpose, i.e. for physical exercise by adult people.
WARNING!
Any other use of the equipment is prohibited and
!
may be dangerous. The manufacturer cannot be held liable for
damage or injury caused by improper use of the equipment.
WARNING!
Before beginning your program of training, study
!
the instructions for training carefully.
WARNING!
All electric appliances emit electromagnetic
!
radiation when in operation. Please do not leave especially
radiation-intensive appliances (e.g. mobile telephones) directly
next to the cockpit or the electronic controlsystem as otherwise
values displayed might be distorted (e.g. pulse measurement.
WARNING!
Do not under any circumstances carry out electrical
!
repairs or alterations yourself. Always ensure that such work is
done by a properly qualified electrician.
WARNING!
disconnect the apparatus from the mains before
!
doing repair, maintenance or cleaning work.
WARNING!
If you lose the pulse signal, the performance of
!
the device will remain constant for approx. 60 seconds and is
then slowly adjusted downwards. Please check your pulse mea-
suring system (ear clip, hand pulse or chest belt) so that the pulse
signal of the electronics can be entered again.
The device requires a supply voltage of 230V, 50 Hz.
■
Connect the power cord with a grounded protective contact
socket.
Do not use a multiple power socket for the running belt. If an
■
extension cable is being used, ensure that it complies with the
VDE regulations.
Unplug the power cord of the device from the socket if not used
■
for a longer period.
Ensure that the power cable is not pinched and that no-one can
■
trip over it.
Handling the equipment
! ATTENTION!
It is not recommended to use or store the appa-
ratus in a damp room as this may cause it to rust. The friction
surface of the flywheel is especially sensitive to the formation
of rust. Should this occur (e.g. after a prolonged period of disuse)
the rust should be removed using sandpaper or steel wool. Do
not use grease or oil! Please ensure that no part of the machine
comes in contact with liquids (drinks, perspiration etc.). This may
cause corrosion.
Before using the equipment for exercise, check carefully to
■
ensure that it has been correctly assembled.
Before beginning your first training session, familiarize
■
4
Exercise has been designed in accordance with the latest stan-
■
dards of safety. Any features which may have been a possible
cause of injury have been avoided or made as safe as possible.
Incorrect repairs and structural modifications (e.g. removal or
■
replacement of original parts) may endanger the safety of the
user.
Damaged components may endanger your safety or reduce the
■
lifetime of the equipment. For this reason, worn or damaged parts
should be replaced immediately and the equipment taken out
of use until this has been done. Use only original KETTLER
spare parts.
If the equipment is in regular use, check all its components
■
thoroughly every 1 -2 months. Pay particular attention to the
tightness of bolts and nuts.This applies especially to the securing
bolts for saddle and handelbars.
To ensure that the safety level is kept to the highest possible
■
standard, determined by its construction, this product should
be serviced regulary (once a year) by specialist retailers.
Before beginning your program of exercise, consult your doctor
■
to ensure that you are fit enough to use the equipment. Base your
program of exercise on the advice given by your doctor. Incorrect
or excessive exercise may damage your health!
Any interference with parts of the product that are not described
■
within the manual may cause damage, or endanger the person
using this machine. Extensive repairs must only be carried out
by KETTLER service staff or qualified personnel trained by KETTLER.
Our products are subject to a constant innovative quality assurance.
■
We reserve the right to perform technical modifications.
In case of enquiry, please contact your KETTLER dealer.
■
In choosing the location of the apparatus, ensure a sufficient safety
■
distance from any obstacles. The apparatus must not be mounted
in the immediate vicinity of main passageways (paths, doorways,
corridors).
For a comfortable training position please adjust the handlebar
■
andsaddle position to your body height.
When mounting the product please take the recommended
■
torque information into account (M = xx Nm).
The exercise cycle complies with the DIN EN 957 - 1/- 5 class
■
HA.
yourself thoroughly with all the functions and settings of the
unit.
The machine is designed for use by adults and children should
■
not be allowed to play with it. Children at play behave unpre-
dictably and dangerous situations may occur for which the
manufacturer cannot be held liable. If, in spite of this, children
are allowed to use the equipment, ensure that they are instructed
in its proper use and supervised accordingly.
A slight production of noise at the bearing of the centrifugal mass
■
is due to the construction and has no negative effect upon ope-
ration. Possibly occurring noise during reverse pedalling result
from engineering and are absolutely safe.