Bissell PROHEAT ADVANCED 1846 Serie Guia Del Usuario página 14

Troubleshooting
WARNING
To reduce the risk of electric shock, turn power OFF and disconnect plug from electrical
outlet before performing maintenance or troubleshooting checks.
Problem
There is no
power to the
machine
Reduced spray
or
no spray
Cleaner
not picking up
solution
ReadyTools™
Dial becomes
difficult to turn
14
www.BISSELL.com
Possible causes
Power Switch is OFF.
Wall outlet may not have power.
Bladder may be empty.
Tanks may not be seated
properly.
Pump may have lost prime.
Pump belt may be broken.
ReadyTools™ Dial may be
on the wrong setting for the
cleaning job.
Nozzle window may not be
properly attached.
2-in-1 Tank lid is not properly
installed.
2-in-1 Tank is not properly
seated.
Poor tool position.
(Handheld attachments only.)
2-in-1 Tank has picked up
maximum dirty water.
Diverter assembly should be
cleaned.
Remedies
Turn Power Switch ON.
Try another working outlet.
Refill bladder with hot tap water.
Turn power OFF (O); remove & reseat
tanks.
Turn power OFF (O); after 1 minute
turn ON and press trigger.
Turn ON the machine and check to see
that the DirtLifter PowerBrush turns.
Set ReadyTools™ Dial to the proper
setting, depending on how you are
using your machine.
Press down firmly on the black oval
gasket at the top window to make
sure the two tabs on the back of the
nozzle window are snapped into the
mating slots in the main housing.
Reinstall lid following steps on
page 8.
2-in-1 Tank must be firmly seated to
function; remove and reseat tank.
Adjust angle; apply more downward
pressure.
Empty tank following steps on
page 11.
Remove the nozzle (page 12) and the
diverter assembly; hold it under running
water, making sure water flows through
and around the dial. Turn the dial
about 10 times clockwise and 10 times
counter-clockwise. This should free up
debris. Wipe the diverter and nozzle dry
and return it to the machine.