Stid ATX UHF INDUSTRY Manual De Instalación página 6

Idiomas disponibles

Horizontal polarization F = 867 MHz

STid declares that the reader is compliant to the Directive RoHs 2011/65/EU.

A copy of our declaration is available upon request send to qualite@stid.com.

Operation is subject to the following two conditions:

1) This device must not cause harmful interference.

2) This device must accept any interference received, including interference that may cause undesired operation.

Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such

modifications could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses

and can emit radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the distance between the equipment and receiver.

Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for assistance.

This equipment complies with FCC's and ISEDC's radiation exposure limits (using RSS-102 rules) set forth for an uncontrolled environment

under the following conditions:

This equipment should be installed and operated such that a minimum separation distance of 34 cm / 13.39 in is maintained

between the radiator (antenna) and the user's/nearby person's body at all times.

The transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

ATEX & IECEX UHF reader

Installation procedure

Horizontal polarization F = 915 MHz

Lecteur UHF ATEX & IECEX

Notice d'installation

Azimuth pattern ATX4

Vertical polarization F = 867 MHz

Azimuth pattern ATX

Vertical polarization F = 867 MHz

Declaration of Compliance

ATEX & IECEX UHF lectores

Manual de instalación

Vertical polarization F = 915 MHz

Atx4 uhf industry