Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
The operation procedures are the same as CD playback.
To disconnect the USB device or SD/MMC card:
• Simply unplug the USB device from the connector or remove the SD/MMC card from the card slot.
Auxiliary input
To connect and listen to your auxiliary source:
Connect your auxiliary source (e.g. mp3 player) to the AUX IN jack at the front of the
1.
unit.
Turn on the unit and your auxiliary source.
2.
Press FUNCTION repeatedly to select AUX mode to listen to the audio input from the
3.
auxiliary source.
•
The AUX indicator shows on the display when AUX mode is selected.
4.
Adjust the auxiliary source to mid-range volume and adjust the master
volume on the unit.
•
Do not turn the volume of the auxiliary source too high as
this may affect the sound quality.
•
For other playback controls, control them on your auxiliary
source.
Troubleshooting tips
General
No power
•
AC connection is not complete. Check all cords and cables.
Unit does not respond to key presses
•
Débranchez le câble d'alimentation, rebranchez-le et essayez de nouveau.
Unable to operate the unit from the remote control
•
The built-in microprocessor may malfunction due to external
•
electrical interference. Unplug the AC power cord and then plug it
•
back in.
No sound is heard
Volume is too low. Increase the volume.
Headphones are connected.
Disc playback
Disc does not play
•
Check that the CD is in the tray.
•
Check that the CD label is facing up.
•
Check that pause mode is not on.
•
Check that the CD function is selected.
CD sound skips
Clean the disc.
•
Check the disc for warping, scratches, or other
•
damage.
•
Check if something is causing the unit to vibrate. If so,
move the unit.
Radio
Poor radio reception
14
Publicidad
Tabla de contenido
Solución de problemas
