Assembly; Assembling The Light - HAMPTON BAY 1000 020 912 Guía De Uso Y Cuidado

Assembly

1

Assembling the light

Align the tabs on the lens (B) with the ledges on the light
head (A) and turn the light head (A) clockwise until tabs
are secure under ledges.
Align the tabs on the shade (C) with the ledges on the
light head (A) and turn the light head (A) clockwise until
tabs are secure under ledges.
NOTE: Some parts may come pre-assembled.
2
Mounting on a post
Firmly slide the light assembly (A, B and C) on top of the
post mount (D) until it is flush.
Attach the light and post mount assembly (A, B, C and D)
to the selected post by aligning the post with the opening
in the bottom of the post mount (D). Set the light onto
the post.
NOTE: Light head should fit on a common 4 x 4
inch post. Actual post measurement: 3-5/8
x 3-5/8 in.
Use a pen or pencil to trace the two holes located on
the sides of the post mount (D) onto the post. Remove
the light assembly.
Pre-drill pilot holes onto the post where your pen/pencil
marks were made.
Slide the light and post mount assembly (A, B, C and D)
onto the post. Insert the screws (AA). Tighten until secure.
A
C
D
4
AA