Matco Tools CSTK78 Manual Del Usuario

WARNING
Study, understand and follow all instructions provided
with this product. Read these instructions carefully before
installing, operating, servicing, or repairing this tool. Keep
these instructions in a safe, accessible place.
INTENDED USE OF THE TOOL
This kit is designed to safely remove and install crankshaft
and camshaft seals without scratching seal surfaces. Do not
use this tool outside of the designed intent. Never modify the
tools for any other purpose or use.
BEFORE USE
Before use, READ AND UNDERSTAND THE WARNINGS ON
PAGE 1 and check the parts diagram and part number listing
on page 7 to make sure all parts are included. If any parts are
missing or damaged, please call your distributor.
Caution: To help prevent personal injury
Normal use of this product is likely to expose the user to
dust and/or microscopic particles containing chemicals
known to the State of California to cause cancer, birth
defects or other reproductive harm. Always wear appropriate
safety equipment and clothing when using this product.
Study, understand and follow all instructions provided with
this product. Failure to read and follow all warnings and
operating instructions may result in damages and serious
injury or death.
product. (Users and bystanders).
it was designed.
modification of the tool, or use of the tool with accessories
not designed for it could result in serious injury or death.
design for the job that you are attempting to perform.
adequately equipped area.
Do not begin repairs without assurance that vehicle is in
secure position, and will not move during repair.
CRANK/CAMSHAFT
SEAL TOOL KIT
The manufacturer warrants this product to the original user
against defective material or workmanship for a period of 1
year from the date of purchase.
The manufacturer reserves the right to determine whether
the part or parts failed because of defective material,
workmanship or other causes. Failures caused by accident,
alteration or misuse are not covered by this warranty.
The manufacturer, at its discretion, will repair or replace
product covered under this warranty free of charge. Repairs
or replacements of products covered under this warranty are
warrantied for the remainder of the original warranty period.
The manufacturer or its authorized service representatives
must perform all warranty repairs. Any repair to the product
by unauthorized service representatives voids this warranty.
The rights under this warranty are limited to the original user
and may not be transferred to subsequent owners.
The warranty is in lieu of all other warranties, expressed or
implied, including warranties of merchantability and fitness
for a particular purpose. Some states do not allow the
exclusion or limitations of incidental or consequential
damages, so the above limitations may not apply to you.
Made in China
to Matco specifications
Comprehensive. Most complete kit on the market includes
CSTK781 Handled Adjustable Seal Puller plus adapters and
threaded puller to easily remove and install crank and
camshaft seals from 21 - 64mm.
Superior durability. Long and short pulling arm sets made
from S2 Tool Steel for twice the bend resistance of
comparable sets while maintaining slim profile for access.
Professional.
seals, when paired with the included hard plated CNC
machined billet aluminum and steel adapters and sleeves.
DO NOT DISCARD – GIVE TO USER
Page 1
1 YEAR LIMITED WARRANTY
PRODUCT INFORMATION
CSTK78
to install
1706208-14