Craftsman 152.211700 Manual De Operaciones página 4

10.
ALWAYS WEAR EYE PROTECTION. Any power tool c anthrow
debris i nto theeyes during o perations, which c ould cause severe
and permanent eyedamage. Everyday
eyeglasses are NOT
safety glasses. ALWAYS wear Safety Goggles (that comply with
ANSI standard Z87.1) when operating power tools. Safety Goggles
are available at Sears Retail Stores.
11. ALWAYS WEAR HEARING PROTECTION. Plain cotton is not an acceptable
protective device. Hearing equipment should comply with ANSI $3.19 Standards.
12. ALWAYS UNPLUG THE TOOL FROM THE ELECTRICAL RECEPTACLE when
making adjustments, changing parts or performing any maintenance.
13. KEEP PROTECTIVE GUARDS IN PLACE AND IN WORKING ORDER.
14. AVOID ACCIDENTAL STARTING. Make sure that the power switch is in the "OFF"
position before plugging in the power cord to the electrical receptacle.
15. REMOVE ALL MAINTENANCE TOOLS from the immediate area prior to turning
"ON" the Utility Sharpener.
16. USE ONLY RECOMMENDED ACCESSORIES. Use of incorrect or improper ac-
cessories could cause serious injury to the operator and cause damage to the tool.
If in doubt, check the instruction manual that comes with that particular accessory.
17. NEVER LEAVE A RUNNING TOOL UNATTENDED. Turn the power switch to the
"OFF" position. DO NOT leave the tool until it has come to a complete stop.
18. DO NOT STAND ON A TOOL. Serious injury could result if the tool tips over or you
accidentally contact the tool.
19. DO NOT store anything above or near the tool where anyone might try to stand on
the tool to reach it.
20. MAINTAIN YOUR BALANCE. DO NOT extend yourself over the tool. Wear oil
resistant rubber-soled shoes. Keep floor clear of debris, grease, and wax.
21. MAINTAIN TOOLS WITH CARE. Always keep tools clean and in good working
order. Keep all blades and tool bits sharp.
22. EACH AND EVERY TIME, CHECK FOR DAMAGED PARTS PRIOR TO USING
THE TOOL. Carefully check all guards to see that they operate properly, are not
damaged, and perform their intended functions. Check for alignment, binding
or breaking of moving parts. A guard or other part that is damaged should be
immediately repaired or replaced.
23. CHILDPROOF THE WORKSHOP AREA by removing switch keys, unplugging tools
from the electrical receptacles, and using padlocks.
24. DO NOT OPERATE TOOL IF UNDER THE INFLUENCE OF DRUGS OR ALCOHOL.
25. SECURE ALL WORK. When it is possible, use clamps or jigs to secure the work-
piece. This is safer than attempting to hold the workpiece with your hands.