When the fuel has drained from the tank, close the fuel
valve and reinstall fuel line securely on petcock.
Reinstall fuel valve knob in generator housing. Push for-
ward until knob snaps securely into position.
DRAINING THE CARBURETOR
Turn the engine switch OFF ( O ).
Turn the fuel valve to the OFF position.
Position a suitable container under the carburetor drain
screw to catch fuel; loosen the screw.
Allow fuel to drain completely into container.
Retighten drain screw.
NOTE: Consult hazardous waste management guidelines in
your area for the proper way to dispose of used fuel.
REPLACING FUEL FILTER
See Figure 21.
Occasionally the fuel filter may become clogged and need
to be replaced. To purchase a replacement fuel filter, contact
customer service or a qualified service center.
NOTE: Fuel tank must be empty before replacing fuel filter.
Run unit until tank is empty, if needed, or inspect filter prior
to fill-up.
All manuals and user guides at all-guides.com
MAINTENANCE
Turn the fuel valve to the OFF position.
Push the fuel valve knob through the generator housing
Remove the fuel line from both sides of the filter by
Slide the fuel line off.
Replace with new fuel filter.
Reinstall fuel lines to new fuel filter.
Reinstall fuel valve knob in generator housing. Push for-
Turn the fuel valve to the ON position.
TRANSPORTING
Turn off the generator.
Turn the fuel valve to the OFF position.
Allow 30 minutes of "cool down" time before transport-
Do not drop or strike unit or place under heavy objects.
If transporting in a vehicle, drain the fuel tank, close the
Provide a plastic sheet or absorbent pad below the gen-
Page 17 — English
and pull down slightly to gain access to the filter.
squeezing the ends of the retaining clip with pliers.
ward until knob snaps securely into position.
ing the machine. Make sure engine and exhaust of unit
is cool.
fuel valve, and securely restrain the generator.
erator to catch any drips of fuel or lubricant.