Faucet Installation - BLACK&DECKER Price Pfister KENZO 23 Serie Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Thank you for purchasing this Price Pfister product. All Price Pfister products are carefully engineered, and factory tested to
provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3
3 TOOLS RECOMMENDED
• PTFE Plumber's Tape
• Plumber's Putty
• Adjustable Wrench
• Pliers
• Cloth
Your installation may require new supply lines and / or shut-off valves or other additional
tools.
4
C
A
E
4 CHECKING THE CONTENTS OF THE BOX
Installation instructions before the fixture is secured to the floor. Fixture Detail:
A Center Hole
B Right End Body Hole
C Left End Body Hole
D Spray Hole
E Drain Hole
F Lift Rod Hole
If any of these items are missing, please contact Price Pfister Consumer Service at
1-800-Pfaucet (1-800-732-8238).
ENGLISH
• Slotted Screwdriver
• Flashlight
F
B
D
2

FAUCET INSTALLATION

5
5D
5C
5C
5A
5A
5B
5 DIVERTER/VACUUM BREAKER VALVE PREPARATION
Use PTFE Plumber's Tape on all threaded parts, per manufacture's instructions.
(Assemble as shown.) From top of Diverter, screw Nut (5A) down to Base of Diverter
(5B). Then slide Washer (5C) and Tapered Rubber Washer (5D) down to Base of
Diverter (5B).
6
6J
6H
6G
6F
6E
6D
6B
6A
6 DIVERTER/VACUUM BREAKER INSTALLATION
This unit can be installed using either a round or square Flange (6H or 6K). From the
bottom of Bidet Fixture (6A), insert Diverter (6B) through the Center Hole (6C). From
the top, slide Tapered Rubber Washer (6D) and Metal Washer (6E) onto Diverter from
top. Tighten the Metal Lock Nut (6G) until Diverter is secured to Bidet Fixture (Do not
overtighten.) Slide Trim Flange (6H) and Plastic Base Plate (6F) onto Diverter from top
and secure by tightening Plastic Lock Nut (6J).
5D
5B
6K
6A
6B
6C

Publicidad

Tabla de contenido
loading

Tabla de contenido