Axxess AX-NIS32SWC Instrucciones De Instalación

Installation Instructions for AX-NIS32SWC
AX-NIS32SWC
Nissan (with 4.3" display radio) 2010-up
INTERFACE FEATURES
• Pre-wired ASWC-1 harness (ASWC-1 sold separately)
• Retains the factory backup camera to an aftermarket radio
INTERFACE COMPONENTS
• AX-NIS32SWC harness
APPLICATIONS
NISSAN
Altima coupe 2010-2013* Juke
Altima sedan 2010-2012* Murano
Altima sedan 2013-up Quest (without Bose)
Cube 2010*
Frontier 2013-up* Rogue
* For use when retaining the OE backup camera only.
TOOLS REQUIRED
• Wire cutter • Crimping tool • Solder gun • Tape
• Connectors (example: butt connectors, bell caps, etc.)
CAUTION!
All accessories, switches, climate controls panels, and especially air bag indicator lights
must be connected before cycling the ignition. Also, do not remove the factory radio with the key in the
on position, or while the vehicle is running.
®
axxessinterfaces.com • metraonline.com
Axxess Integrate
REV. 11/22/16 © COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
2015-up* Rogue 2014-up
2015-up Rogue Select 2014-2015*
Sentra 2010-up*
2011-up* Titan 2013-2015*
2011-2013* Versa Note 2014-up*
Installation Instructions for AX-NIS32SWC
Connections to be made
• Connect the Black wire to chassis ground.
• Connect the Red wire labeled "Camera Power 6V" accessory power. *
• Connect the Green/Purple wire to the reverse wire of the aftermarket radio.
• Connect the Yellow RCA jack to the rear camera input of the aftermarket radio.
*
It is highly recommended to use the AX-CAM6V (sold separately) to provide
the camera with the proper voltage.
12-pin pre-wired ASWC-1 harness:
For the Altima sedan 2013-up / Rogue 2014-up only:
This harness is to be used along with the optional ASWC-1 (not included) to
retain steering wheel audio controls. Please refer to the ASWC-1 instructions
for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
• Connect the unlabeled Red wire to the accessory wire.
K P
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
®
axxessinterfaces.com • metraonline.com
Axxess Integrate
REV. 11/22/16 © COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
OWER
Metra recommends MECP
certified technicians