MOTOAIRBAG S164S Manual De Istrucciones página 10

ENGLISH
PRODUCER
D.P.I. Safety s.r.l. – s.s. dei Giovi 11/13 – 20080 Badile – Milan – Italy .
tel +39.02.9053806 – www.motoairbag.com – info@motoairbag.com
INTEDED USE
MOTOAIRBAG ®
is designed only for use on roads regulated by a government highway traffic
PROTECTION ZONE
®
MOTOAIRBAG provides protection to the back, neck and sacral area.
SIGNIFICANCE OF THE CE MARKING
The CE mark on Personal Protective Equipment (PPE) items indicates compliance with the Directive 89/686/CEE (plus subsequent modifications)
including certification procedures found in Chapter II of the directive.
This directive describes, in detail, the manufacturer's obligations in order to comply with CE requirements relating to the product to be certified. The CE
mark also signifies the protector has successfully completed the procedures of CE type approval and certification.
MOTOAIRBAG ®
PPE has undergone the appropriate analysis for CE certification at Notified Body nr. 0498 (RICOTEST, via Tione, 9 37010 Pastrengo
Verona - Italy), which certified the compliance with the requirements of the European directive 89/686/CEE (plus subsequent modifications) and
applicable requirements of the standard EN1621/4:2013.
HOW TO USE MOTOAIRBAG

Always wear MOTOAIRBAG

Always fasten the front buckle of the belt to secure the airbag to your body

Adjust the internal harnesses so they are snug to the body

Fasten the front buckle of the shoulder straps (if present)

Close frontal zipper (For model S11 - MAB v2.0c Close MOTOAIRBAG

Adjust the external lateral straps, if present.

Ensure the D-ring belt is properly secured to the motorcycle seat

Ensure the seat is properly secured to the motorcycle

Connect activation cable to the D-ring belt (secured to the motorcycle) prior to moving

Before get off the motorbike, unhook the activation cable
MOTOAIRBAG ®
may not work correctly if instructions are not carefully followed.
Contact the manufacturer or authorized dealer if any questions about these instructions
REGISTRATION OF SERIAL NUMBER
MOTOAIRBAG ®
airbag systems are 100% tested. Every airbag system has serial number which shall be communicate to D.P.I. Safety by mail (using
registration chart on MOTOAIRBAG
®
®
over your existing riding jacket or suit.
®
) or on the web site www.motoairbag.com
act.
®
as described in page 32)
10