Lcd Display; Rear Panel - Urmet 1092/694 Manual De Instrucciones

MON
MAIN/AUX
AUX
F1
EDIT
A
SHUT DOWN
F2
F3
F4
Addr
2.3

LCD DISPLAY

All operations will be shown on the display immediately.
The display will automatically go to power saving mode if no button is pressed for about 30 seconds.
2.4

REAR PANEL

ITEM
1
2
3
4
5
6
7
8
9
Important note:
RS-485 connections must observe polarity.
Check that the proper termination resistors (120 Ohm) are connected to RS-485 line ends.
DS1092-109 A
It allows to switch the selected video channel from spot output to main output
Reserved for future uses
In DVR menus it allows to go the next card
Reserved for future uses
Enter data during DVR programming
In character-entering mode it allows to select the kind of characters to be entered
Turn the DVR off; confirm by pressing the button
Reserved for future uses
Reserved for future uses
Reserved for future uses
It allows to select the device address to control.
Press the Addr+NUM+ENTER key to recall the Dome or the DVR to check according to the
"check DVR" mode or "check PTZ" mode
RS-485 line data output connectors for PTZ devices control: Ta (+) and Tb(-)
RS-485 line signal input connectors for PTZ devices control from auxiliary
keyboards (reserved for future uses)
Connectors for ground connections, if needed
RS-485 line signal input connectors for DVR control from auxiliary keyboards
RS-485 line data output connectors for DVR control: Ta (+) and Tb(-)
Green led to signal "PTZ control" operating mode
Green led to signal "DVR control" operating mode
Enter
DESCRIPTION
(reserved for future uses)
Power supply red led
Power supply connector
16