Urmet 1092/694 Manual De Instrucciones página 18

Press Enter to confirm; the keyboard buzzer will confirm that the change has been successfully executed.
After all the configurations have been completed, press the button Esc for 3 times to go back to Dome management
mode.
Important note:
If the same protocol type or the same baud rate value must be configured for all the addresses, when the keyboard display
shows CAM: 001, move the joystick up or down until the display shows CAM: 0-255, then select the desired protocol type
and the baud rate value.
On the keyboard, keep the button Setup pressed for 3 seconds and enter the default password "8888"
On the keyboard, press the button Enter: the keypad display will show PTZ SETUP
Move the joystick down; the keyboard display will show SYS SETUP
Move the joystick down; the keyboard display will show:
•
PW SETUP: the setup password can be changed (that is, it is possible to configure the new password,
replacing the default password "8888" to change keyboard parameters).
•
DEFAULT SETUP: restore factory default settings.
•
SOUND SET: enable/disable button sound.
•
HOST ID SET: configure keyboard ID.
On the keyboard, press the button Search; the display will show protocol and baud rate. Move the joystick down to
display information about PTZ parameters configured on the keyboard, as protocol and baud rate, or settings
concerning system parameters configured on the keyboard (password, button sound, password for keyboard
protection, keyboard ID, etc.)
DS1092-109 A
System parameters configuration
Keyboard info
18