Password And Access To Keyboard; Programming With Keyboard - Urmet 1092/694 Manual De Instrucciones

3

PASSWORD AND ACCESS TO KEYBOARD

The 1092/694 keyboard manages two 4-digit passwords:
one Password for the system administrator, to perform any operations on Dome and keyboard (default value:
"8888");
one user password: instead of the previous one, this does not allow to change keyboard programming, but only
movements commands (not present by default).
To access control and programming, enter the 4 digits of the password in use.
4

PROGRAMMING WITH KEYBOARD

PTZ SETUP
SYS SETUP
For all programming operations with keyboard, use the joystick to scroll menus and change parameters.
On the keyboard, keep the button Setup pressed for 3 seconds and enter the default password "8888"
On the keyboard, press the button Enter: the keypad display will show PTZ SETUP
On the keyboard, press the button Enter; the keypad display will show CAM: 001
With the numeric keyboard, enter the three digits of the PTZ address of the dome connected, to change protocol type
and baud rate default configuration of this dome; alternatively, move the joystick right or left to increase or decrease
the PTZ device number to be programmed.
After selecting the address, press the button Enter to confirm; the keyboard display will show PROTOCOL: Pelco-D
(protocol used in Urmet Domus products);
Move the joystick right to change protocol type; the keyboard display will show the other protocols
Press Enter to confirm; the keyboard buzzer will confirm that the change has been successfully executed.
Move the joystick up or down to select the baud rate; the keyboard display will show the baud rate value BAUD
RATE:9600
To change the baud rate value move the joystick left or right
DS1092-109 A
CAM: xxx
PW SETUP
DEFAULT SETUP
SOUND SETUP
HOST ID SETUP
Protocol and baud rate configuration on keyboard
PROTOCOL
BAUD RATE
OLD PW
NEW PW
AGAIN PW
ON
OFF
HOST ID
17
000 ÷ 255
Pelco-D, Pelco-P, etc.
1200, 2400, 4800, 9600, 19200