Stanley QED311 Manual Del Usuario página 5

C
Exit Device Installation
1
Chassis
Cover
Remove the chassis cover
from the exit device.
3
Insert end cap bracket to
end of device and mark
screw hole centers. Remove
bracket and prepare door with
appropriate screws as shown
on template. Secure bracket
to door with appropriate
screws.
D
Install Strike
1
Install strike (and
shim if required) with
appropriate screws.
Adjust strike to make
sure the latch of device
engages within the
strike securely, before
tightening screw firmly.
2
Place exit device onto door,
keeping it horizontally level
and aligning mounting holes
with holes drilled. If you have
an exterior trim that has an
actuating shaft or a tailpiece,
you must allow shaft or tailpiece
to align inside the cam of exit
device. Mount exit device with
appropriate screws, either by
engaging with exterior trim or
securing directly onto door.
End Cap
Bracket
2
For a fire rated strike:
Once adjusted and
mounted, drill a 1/8"
(3mm) diameter pilot
hole for center screw.
Insert screw and tighten.
4
Notes
Dogging
Device
Counter-clockwise
For Product with Dogging Device:
Use the dogging device to extend the life of the exit
device during high traffic periods.
To Set Dogging Device:
Depress the push bar, insert the hex wrench and turn
clockwise 35°—this will allow the push bar to remain
depressed with the latch retracted.
To Release the Dogging Device:
While keeping push bar depressed, insert hex
wrench and turn counter-clockwise 35° to release to
3/8
Mounting holes
Cam
End Cap
Install end cap and chassis
cover with screws provided.
35°
Clockwise
35°
Hex Wrench
normal function.
Chassis
Cover