Zenith ZP305MH Manual Del Propietário página 4

Manual Code Search:
Try this search option if your brand of your device is
not listed in the table above.
1. Turn on the device you wish to program for use with
this remote.
2. Point the remote at the device and press and hold the
Device Button until the Power Indicator Light stays
on. Release the Device Button.
3. Press the "CH+" or "CH-"Button on the remote
repeatedly (up to 300 times). When the device shuts
off, immediately press OK to save the code. The
Power Indicator Light will shut off.
4. Press the Power Button on the remote. If the device
turns on, the programming was successful. Test other
buttons on the remote to ensure total success.
5. If the device does not turn on, or if all of the other
buttons do not work correctly, go back to step 2 to
try this search option again, or go to the Auto Code
Search section.
6. During the search process, you can press CH+ or
CH- to change the direction of the search. a. If the
device shuts off and "CH+" is pressed again ac-
cidentally, press "CH-"change same number of times
with to reverse direction to get back to the code that
worked. Then press OK to save the code.
Auto Code Search:
Try this search option if the brand of your device is not
listed in the table above.
1. Turn on the device you wish to program for use with
this remote.
2. Point the remote at the device and press and hold the
Device Button until the Power Indicator Light stays
on. Release the Device Button.
3. Press and release the Power Button on the remote.
The Power Indicator Light will flash once every two
seconds. When the device shuts off, immediately
press OK to save the code. The Power Indicator
Light will shut off.
4. Press the Power Button on the remote. If the device
turns on, the programming was successful. Test other
4
buttons on the remote to ensure total success.