Description
1
Foil protection cap
2
Shaver foil
3
Cutter block
4
Long hair trimmer
5
Charging light
6
On/off switch
7
Special cord set
Charging
The best environmental temperature for charging is between 60 °F to 95 °F/
15 °C to 35 °C.
•
Using the special cord set, connect the shaver to an electrical outlet with
the motor switched off.
•
When charging for the first time, leave the shaver to charge continuously
for 4 hours. The green charging light (5) shows that the shaver is being
charged. When the battery is fully charged, the charging light intermit-
tently blinks on and off. This indicates that the battery maintains its full
capacity.
•
A full charge provides up to 30 minutes of cordless shaving time
depending on your beard growth.
•
Once the shaver is completely charged, discharge the shaver through
normal use. Then recharge to full capacity. Subsequent charges will take
about 1 hour.
•
Maximum battery capacity will only be reached after several charging/
discharging cycles.
•
If the rechargeable batteries are discharged, you may also shave by
connecting the shaver to an electrical outlet via the special cord set.
Shaving
Remove the foil protection cap (1). Activate the on/off switch (6). The floating
foil frame automatically adapts to your skin surface for a close, smooth
shave.
For pre-shaving after a few days of not having shaved, use the long hair
trimmer (4) to pre-cut long hairs. For a close, smooth shave, finish with the
foil.
8