Kenmore 119.16126011 Manual De Uso página 22

BEFORE AND AFTER LIGHTING
• Ensure your grill is located on a level surface and
use the adjustable feet as necessary to stabilize.
• Keep the gas grill area clear and free from
combustible materials, gasoline, and other
flammable vapors and liquids.
• Ensure nothing is obstructing the flow of
combustion and ventilation air.
, Ensure the ventilation openings of the cylinder
enclosure are free and clear of debris.
• Visually check burner flames.
, Never move the grill when it is hot.
• Never lean over the firebox and burners when
lighting the grill.
• Grills are ventilated for safety and performance
reasons. Closing the hood on a grease fire will
not extinguish the fire.
• Do not put water on a grease fire. If a grease
fire starts, turn the control knobs and LP
cylinder off. Flour may be used to help
smother a grease fire.
• Do not leave a grill unattended when
preheating, cooking, or cleaning. A grease fire
can occur during these events if grease has
been allowed to collect by not regularly cleaning
the grill.
5.
6.
7.
seconds, turn the burner control knob to "OFF".
Wait for 5 minutes for the gas to clear and repeat
the lighting procedure.
Repeat step 4 to light other burner.
Follow the match lighting instructions below if
burners do not light.
When lit, turn the burner control knob to its
desired heat setting.
Burner Electronic Ignition
MATCH=LIGHTING A MAIN BURNER
o Open the lid.
o Insert a match into the match holder, Ignite the
match and insert through the cooking grates and
hold next to the burner
o Push in a burner control knob and turn left to # Hi.
Continue to press in on the control knob until the
burner ignites. The burner should light
immediately.
= If the burner does not light within 5 seconds, turn
the control knob to the "OFF" position, wait 5
minutes for gas to clear and try again.
1. Read instructions before lighting.
2. Open lid during lighting.
3. If igntion does not occur in 5 seconds, turn the
burner control knob off, wait 5 minutes and
repeat the lighting procedure.
LIGHTING THE MAIN BURNERS WITH
ELECTRONIC IGNITION
1. Open the lid.
2, Ensure the burner controlknobs are inthe "OFF"
position.
3. Turn on the LP gas by slowly turning the hand
wheel on the cylindervalve.
4, Push in a burner control knob and turn left to
Hi. Immediately press the electronic ignition
button for 3 to 5 seconds. You should hear a
clicking sound which shows the electronic igniter
is working. If burner does not light within 5
TURNING OFF YOUR GRILL
1. Turn burner controlknobs to the "OFF" position.
2. Turn offthe gas supply at the LP tank by turning
the valve clockwise.
22