Components; Warnings; Start Up - Sagola 3300 GTO Manual De Instrucciones

1 Regulator
2 Air outlet
3 Pressure gauge
4 Non return valve
Before putting the unit into operation, and
especially after each cleaning and/or repair
operation, a check must be made that the
components are securely tightened.
Before putting the unit into operation, we
recommend you to clean the gun and
product cup as this has been subjected to
functional tests and before packaging it is
treated internally with a protective coating,
some of which may still remain. Apply thinner
to eliminate this. Remove any residual
grease applied during assembly.
VERY IMPORTANT! All adjustments must
be made with the product cup full of paint. It
is a high precision micro-regulator and its
use isn't envisaged for high air flow rates.
Always keep in mind! High airflows in this
1.- Screw the product
cup to the product inlet
fitting of the spraygun.
2.- The product cup may be filled with
material up to 2 cm below its edge and tightly
screw on lid.

5. COMPONENTS

4

6. WARNINGS

7. START UP

- 12 -
2
1
micro-regulator cause
vibrations, malfunction
breakage.
The regulated pressure in the tank is usually
around 0.05 bar, which is more than enough
for the most viscous products. In no case
should it exceed 0.2 bar for the safety of the
equipment.
Don't open the lid on the product
cup without checking first that the
built-in pressure gauge reads zero.
3.- Connect plastic air
hose of The SAGOLA
gravity cup pressure
kit to non drip plug.
Check the length of it
and make sure it's not
forced.
3
resonances and
and sometimes