Additional Safety Instructions For Hammer Drills - GMC RHD850 Manual Del Usuario

b. Do not use the power tool if the switch does not turn
it on and off. Any power tool that cannot be controlled
with the switch is dangerous and must be repaired.
c. Disconnect the plug from the power source before
making any adjustments, changing accessories, or
storing power tools. Such preventive safety measures
reduce the risk of starting the power tool accidentally.
d. Store idle power tools out of the reach of children and
do not allow persons unfamiliar with the power tool
or these instructions to operate the power tool. Power
tools are dangerous in the hands of untrained users.
e. Always unplug your power tool when leaving
unattended. Such preventative safety measures
reduce the risk of starting the power tool accidentally
by untrained users.
f. Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and
any other condition that may affect the power tools
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.
g. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
h. Use the power tool, accessories and tool bits etc.,
in accordance with these instructions and in the
manner intended for the particular type of power
tool, taking into account the working conditions and
the work to be performed. Use of the power tool for
operations different from those intended could result in
a hazardous situation.
5. SERVICE
a. Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is maintained.
Additional Safety for Hammer Drills
For safety relating to protective clothing/equipment and
general health hazards relating to power tools; refer to
General and Electrical Safety sections in this manual
• Important: It is imperative to follow all national safety
regulations concerning installation, operation and
maintenance
• Use metal and voltage detectors to locate concealed
electric, water or gas lines. Avoid touching live
components or conductors
• Extension cable reels used with this tool must be
completely unwound. Minimum conductor cross section:
1.0mm
2
• When using this tool outdoors, connect to a power
supply with an RCD device and minimum 1.5mm2
extension cable with water protected plugs in good
working order
• Ensure that the chisel or drill bit is securely fixed in
the chuck. Insecure drill bits can be ejected from the
machine causing a hazard
• Use both hands when operating this tool
• Always disconnect the hammer drill from the electric
supply before changing a chisel or drill bit
• Ensure that a chisel or bit is securely fixed in the chuck.
Insecure chisel and drill bits can be ejected from the
machine causing a hazard
• Examine the chuck regularly for signs of wear or
damage. Have damaged parts repaired by a qualified
service centre
• Always wait until the drill has come to a complete stop
before putting it down
• On completion of the work, disconnect the tool from the
power source and remove chisel/bit from the machine
5
GB