Braun SyncroPro Clean&Renew 7680 Manual Del Usuario página 12

12
• Slide down the contact bow to connect the shaver and
to start the selected program.
If no program is selected, the default function «clean» will
be started.
The display of the shaver shows the remaining time of
the running program in 5-minute steps.
• Do not interrupt a running program, as it leaves the
shaver wet and not fit for use. If interruption is needed
nonetheless, press the release button.
• After a program has finished, the corresponding light will
go out. Prior to the next shave, press the release button
to release the shaver.
• When the «cartridge» light starts flashing, the remaining
fluid in the cartridge is sufficient for approximately 5
more cleaning cycles. After these 5 cycles, the cleaning
performance will be reduced and the cartridge has to be
replaced.
• When the «cartridge» light illuminates constantly, the
cleaning function is locked and a new cartridge has to be
installed.
Only then, the next cleaning cycle can be started.
• A cleaning cartridge should be sufficient for about 30
cleaning cycles. With daily use, the cleaning cartridge
should be replaced approx. every 4 weeks.
• The hygienic cleaning solution cartridge contains alcohol
which, once opened, will naturally evaporate slowly into
the surrounding air. Each cartridge, if not used daily,
should be replaced after approximately 8 weeks.
• Clean the housing from time to time with a damp cloth,
especially the opening where the shaver rests.
Accessories
Available at your dealer or Braun Service Centers:
Refill cartridge (double pack) CCR 2, (# 5331)
Subject to change without notice.
For electric specifications, see printing on the special cord
set.