Location Of Controls; Battery Precautions - BRONDI SD-10 Manual Del Usuario

TOP
. ON/OFF Button
2. OGM (Outgoing Message ) Button
3. OGM2 (Outgoing Message 2) Button
4. SPK/MONI Button
5. MEMO Button
6. STOP Button
SIDE
2. Sliding Volume Knob
REAR
3. DC Jack (9V input)
5.TO PHONE Jack
Follow these precautions when using batteries in this device:
. Use only 9V(6LR6 or same type) of battery.
2. Be sure to install the battery in correct polarity. Reversed batteries may
cause damage to the deveice.
3. If the device is not to be used for a long period of time, remove the
battery to prevent damage or injury from possible battery leakage.
4. Do not try to recharge batteries not intended to be recharged; they can
overheat and rupture. (Follow battery manufacture's directions.)
This section has been designed to provide a reference guide to help set up your answering machine.
. Connect one end of the provided telephone line cord into the TO LINE jack. Plug the other end
into the telephone wall jack. You can link the other telephone to this answering machine with the
short telephone line cord. Plug one end of the short telephone line cord to the TO PHONE

LOCATION OF CONTROLS

7. PLAY/Pause Button
8. DELETE Button
9. RING/Button
0. CODE/◄◄ Button
. LED Display
4. TO LINE Jack
6. Battery Compartment (Bottom of Unit)
DC 9V
LINEA TEL
CANC
ON/OFF
ANN1
ANN2
MEMO
ASC

BATTERY PRECAUTIONS

BATTERY PRECAUTIONS
/SQUIL
PIN/
EN