Publicidad
Idiomas disponibles
Idiomas disponibles
Model 32-TTC:
Tools Needed:
– Medium Phillips head screwdriver.
1. Place the tank collar bracket on top of the
center plate. Be sure the mounting bolt knob is
on bottom as shown in Figure 4
2. Insert machine screw into top hole using
Phillips head screwdriver.
3. Insert 2nd machine screw into bottom hole.
This will secure the tank collar bracket to the
center plate.
WARNING
Tip over Switch
Assembly
Swivel
Manifold
Tank Collar Bracket
Figure 4
© 2015, Pinnacle Products International, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A FUEL SOURCE
Assembly
Machine
Screws
Regulator
Knob
Fuel Connector Nut
Mounting Bolt Knob
Model 47-TTC:
Tools Needed:
– Medium Phillips head screwdriver.
1. Insert the mounting bolt knob into the tank
collar bracket.
2. Place tank collar bracket on the swivel bracket.
3. Place the plane washer on the tank collar
bracket and then insert the support bolt.
(See Figure 5)
4. See Figure 6 on page 7 for determining burner
position options.
Swivel Bracket
Regulator
Knob
Figure 5
Propane Tank Top Heater User's Manual
6
Plane Washer
Fuel Connector Nut Tank Collar Bracket
Wing Nut
Mounting
Bolt Knob
Publicidad
