Pinnacle MASTER MH-16-TTC Manual De Usario E Instrucciones De Operacion página 8

47-TTC (Continued):
– To have all 3 burners face front, the plane
washer should be to the right side of tank collar
bracket. (See Figure 6)
Figure 6
Petroleum Gasses and ANSI/NFPA 58.
Inspect the hose and regulator prior to each use
of the heater. If there is excessive abrasion or
wear, or if the hose is cut, replace it with the
proper assembly shown in the parts list prior to
using the heater.
Model 16-TTC:
1. Be sure that the control knob on the regulator
is in the "OFF" position.
2. Line up the threads on the fuel connector nut
with the threads on the LP cylinder valve. Turn
fuel connector nut COUNTERCLOCKWISE to
tighten. Fully tighten the nut, being careful not
to over tighten.
3. Slowly open the LP cylinder valve.
© 2015, Pinnacle Products International, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A FUEL SOURCE
Assembly
7
– To have far left burner face back, the plane
washer should be to the left side of tank collar
bracket. (See Figure 6)
Models 32-TTC / 47-TTC:
1. Be sure that the control knob on the regulator
is in the "OFF" position.
2. Line up the slots in the tank collar bracket
with the tank collar ring and slide into place.
Be sure the mounting knob is to the outside,
and tighten.
3. Line up the threads on the fuel connector nut
with the threads on the LP cylinder valve. Turn
fuel connector nut COUNTERCLOCKWISE to
tighten. Fully tighten the nut, being careful not
to over tighten.
4. Slowly open the LP cylinder valve.
WARNING
the heater.
Propane Tank Top Heater User's Manual
.