Getting Started - DragonTouch DT40 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
② Notifications Icons Overview
Icon
Description
No Signal
Low battery
Feeding Notification
② Notifications Icons Overview
Light Colour
Description
Charging Indicator
Working Indicator
Volume Level Indicator

GETTING STARTED

1. Powering Camera Unit
Connect the Camera Power Adapter to the Camera Unit.
Position your Camera Unit no less than 3 feet away from your baby`s crib. Ensure the
power cord is not within reach of your baby.
06
2. Charging and Powering the Monitor Unit
For best results, charge the Monitor Unit before use. After the initial charge, recharge
normally as required. The Monitor Unit can be operated normally with power adapter
plugged into the unit.
① Plug the USB Output adapter into the electrical outlet. Connect the small end of the
USB Power Cable to the USB DC Jack of the Monitor Unit.
② Press and hold the
Power On/Off/Menu Button for 2 seconds to turn ON the
Monitor Unit. The Power LED indicator will illuminate green to indicate the unit is ON.
③ Once both the Camera and Monitor Units are switched on, the display on the Monitor
Unit will show the video captured by the Camera Unit.
④ If there is no connection or you are out of range, the video display will go off and the
unit will also beep. Move the Monitor Unit closer to the Camera Unit until the link is
re-established.
Note:
The
battery icon turns red on the LCD screen to indicate that the battery is low,
and it gives a beep periodically. The battery needs to be recharged. Fully charging the
battery takes about 5 hours.
3. When Charging
① During power OFF, when adapter is plugged in, the Charging LED indicator will
illuminate red to indicate charging, then the Charging LED indicator turn off to indicate
that the battery is fully charged.
② During power ON, when adapter is plugged in, the battery icon on the screen's top
right corner will show that the battery is charging. The Charging LED Indicator will also
illuminate red to indicate charging, then turn green to indicate the battery is fully
charged.
07

Publicidad

Tabla de contenido
loading

Tabla de contenido