DragonTouch DT40 Manual Del Usuario página 9

3. Camera Control
• Add (Pair) a Camera
① Press Menu Button and the menu bar will pop up. Press the "+"
Left
Button until Camera icon is highlighted.
4.3" LCD
28°C
② Press OK Button to enter to the interface. Camera 1 is the default setting. Press the "+"
Right Button or "-" Left Button to select the desired CAM, and press the OK Button to
start searching for a Camera Unit.
4.3" LCD
28°C
2
1
12
Right Button or "-"
CAM-1
OK
CAM-1
3 4
OK
③ Press and hold the PAIR key behind the Camera Unit for at least 3 seconds.
Then the connection is successful.
Note: A Camera Unit can only be registered to one Monitor Unit at any one time.
• View and Scan Camera
These two functions are only useful if you have more than 1 Camera Unit paired. Scan
camera function automatically cycles through your paired camera channels to display each
camera for 20 seconds.
Press OK Button to select the desired Camera Unit to view or select to Scan the cameras.
When under Scan mode the screen will display the video from different paired cameras in
a loop of SCAN1 / SCAN2 / SCAN3 / SCAN4, changing every 20 seconds.
13