Remote Control Functions - ADS Technologies TV Elite XGA Guia Del Usuario

NTSC and PAL Switch
To switch between NTSC and PAL TV systems:
1. Press the MENU and SELECT buttons at the same time.
2. You will notice the TV display change to accept either the NTSC
or PAL signal.
3. To Switch back, Press MENU and SELECT at the same time
again.
Power Down mode
The Power Down mode switches the XGA to a power saving mode.
The TV screen will immediately go blank when Power Down is activated.
The Red Power light will remain on. This is because the system is
waiting for the Full Power mode.
To Activate Power Down mode:
1. Press MENU and RIGHT button at the same time.
2. You will see the TV Screen go Black.
To enter Full Power mode:
1. Press MENU button
2. TV Screen will display computer image.

Remote Control Functions

Power - Press to Power on unit. Press again to put the unit into a low
power state. Red Power light will stay on.
Brightness – Press repeatedly to select any of the 4 Brightness
settings
Sharp - Press either Sharpness button to select any of the 8
sharpness settings
Width – This sets the UnderScan/OverScan mode
F = Freeze – This will Freeze the image on the TV. This allows you to
make changes on the Computer without your audience watching.
Press the Freeze button a second time to Un-Freeze.
+ = Zoom - Zoom to 200% original size. Press again to Zoom back
out to normal size.
Position keys - Up, Down, Left and Right– Use in Zoom mode to pan
around the TV image. When not Zoomed, you can position the TV
image Up, Down, Left or Right.
H = Home – Press the Home button to center the image on the TV.
12