Assembly And Adjustments - Genesis GLSN08B Manual Del Operario

UNPACKING AND CONTENT
IMPOrTANT
is faulty or that a part is missing. If you find anything wrong, do not operate the tool until
the parts have been replaced or the fault has been rectified. Failure to do so could result
in serious personal injury.
CONTENTS IN PACKAGE
Description
Stapler/Nailer
Charging Stand
Stapler Base
3/8" Brad Nails

ASSEMBLY AND ADJUSTMENTS

WArNING:
important safety warning and instructions before using this tool.
WArNING:
removal of the battery pack.
INSTALLING OR REMOVING THE BATTERY
PACK (FIG 2)
• To install the battery pack, insert the battery pack (2) into the
end of the tool handle all the way until it locks in place with a
click, as shown in fIG 2.
• To remove the battery pack, slide the battery locking tab (3) as
shown in fIG 2, to release the battery pack, then remove the
battery pack.
LOADING STAPLES OR NAILS (FIG 3)
WArNING:
the locked or off position before any assembly, adjustments or changing accessories.
To Load the Staples
1. Hold the tool upside down.
2. Squeeze the magazine release (7) and slide the magazine open.
3. Insert the staples into the channel with the crown side down
and the legs facing upward. See fIG 3.
4. Close the magazine by pushing it into the tool until it clicks.
To Load the Nails
1. Hold the tool upside down.
2. Squeeze the magazine release (7) and slide the magazine open.
3. Load the Brad Nails, with the legs facing upward, into the
channel on the side with the nail symbol. See fIG 3.
4. Close the magazine by pushing it into the tool until it clicks.
NOTE:
The refill indicator window, on the side of the tool, lets the user know when the tool is running low on
staples or nails.
8
:
Due to modern mass production techniques, it is unlikely the product
:
QTY Description
1 Battery Pack (GLAB08B)
1 Charging Adaptor
1 3/8" Staples (J21/#53)
500 Operator's Manual
To reduce the risk of serious personal injuries, read and follow all
Always be sure that the tool is switched off before insertion or
Always disconnect battery pack from tool or place the switch in
8V Lithium-ion Stapler/Nailer
Operator's Manual
QTY
1
1
500
1
7
GLSN08B
3 2
FIG 2
7
Nail Symbol
FIG 3