Polk Audio LCi-RTS105 Manual Del Propietário página 5

PAINTING IN-WALL GRILLES
Painting in-wall grilles
The LCi-RTS105 is supplied with two grilles,
one perforated aluminum, the other cloth-covered
plastic. The perforated aluminum grille may be
painted, while you may dye the cloth grille.
Required tools:
1. Paint of your choice (grilles
must be spray painted).
2. A paperclip or corkscrew (for
removing the paintable grille).
3. Masking tape
4. Paint mask (supplied; covers un-paintable parts)
Preparation:
1. Separate the parts of the speaker. If the speaker
is not yet installed, the grille can be removed
simply by pushing the clamp screws forward
to push the grille off the speaker from the inside.
2. Remove the cloth scrim from the inside of the grill.
3. When painting the speaker frame, use the supplied
paint masks to carefully mask off the front of the
speakers to protect the drivers and baffles. You can
do this while the speaker is already installed in the
wall (if, for instance, you're repainting the room).
If you do not have the paint masks, carefully mask
the speaker components using paper and masking
tape. Use a paper clip to remove the grille.
Painting the aluminum mesh grille:
The grille of the LCi Series speaker features an
even, protective paint. This paint is an ideal primer.
1. Paint the grille.
Note: Grilles must be spray painted. Do not use
a brush and paint. Thick, brushed paint may clog
the grille holes. Use thin coats of spray paint.
If you're using a compressor and spray gun, use
the finest, most diffused setting. Be careful not
to fill the holes in the grille with paint.
2. When the paint is completely dry, carefully
reinstall the grille by fitting it into its recess so
that it is just resting on the frame. Starting with
one corner, go around the speaker and push the
grille into the grille notch a little bit at a time.
Be gentle; the grille may be easily bent by rough
handling. You will feel a positive "snap" when
the grille is fully in place.
Painting the frame:
1. Apply paint to exposed (unmasked) parts.
Use two or more thin coats.
2. When the paint is completely dry, remove
the masking material.
Hook up the speaker wires.
For more information visit our website at www.polkaudio.com 5