Installation - ETI 54677441 Guía De Uso Y Cuidado

Installation

Select a suitable location that can support the weight of the fixture. Determine the method of mounting before drilling.
WARNING: RISK OF ELECTRIC SHOCK. Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off the
circuit breaker before removing the existing light fixture or installing the new one.
With power disconnected to your electrical box, remove the existing fixture. Make a sketch of how the current fixture is wired (by wire
color) or mark the wires with masking tape and a pencil so you will know how to properly reconnect the wires to the new LED light fixture.
1
Separating the diffuser from the housing
Press down gently on one end of the diffuser (B) until you meet with resistance from the bottom of the end cap of the housing (A).
Slide the diffuser (B) toward the end being pressed down.
Lift the diffuser (B) from the other end, removing it from the housing (A).
2
Marking the mounting location
With help from another person, temporarily
hold the fixture housing (A) up to the ceiling to
determine the best mounting position and which
knockout hole to use for wiring the fixture.
Mark four keyhole locations for mounting.
B
Keyholes
5
Knock out holes
Please contact 1-855-384-7754 or further assistance.
B
A
www.ETiSSL.com