ScorpionExo VX-21 AIR Guia De Inicio Rapido página 4

Securing and Wearing
EN
Your Helmet
Do not simply pull your helmet down onto your head like a hat. Your
ScorpionExo ® helmet should be worn as follows: Using both hands grab
the helmet's bottom rim while holding the chin straps with your thumbs.
Then "roll" the helmet onto your head starting at the forehead. Continue
rolling the helmet on towards the back of the head until it comes to rest
with your head fully in contact with the inner lining and cheek pads.
HOW TO USE CHINSTRAP
FIRMLY AND SECURELY FASTEN YOUR CHINSTRAP.
Check your chinstrap for tightness occasionally as vibration or wind may
loosen it.
Cleaning Your Helmet System
None of the components of your ScorpionExo™ helmet can be damaged
by water. All headliners and sweat-wicking cheek pads are machine
washable. Wash them with a mild detergent in warm water and allow to
air dry. Hand washing is recommended, but machine washing is also
permitted. Use the "delicate" cycle to prevent the agitator from damaging
the the sweat-wicking material covering the liner parts, we recommend
5
to place the parts in a washing bag. Do not place lining parts in
the dryer: Excess heat may damage the foam and coverings.
The shell of your helmet should be cleaned using only a mild
detergent and water. NEVER USE PETROLEUM BASED CHEMICALS,
SOLVENTS, GASOLINE, CLEANING AGENTS OR ADHESIVES to clean
the shell or liner since damage may occur.
Warning
For your safety, it is important that you completely read the
owner's manual and all warning labels.
Although there is no visible damage on your helmet, general wear
and tear over time may affect overall function of protective
helmet and increase the risk of injury in accident. It is advisable
to replace your helmet no later than every 5 years from purchase.
DO NOT
DO NOT ride without snugly fastening your chinstrap.
DO NOT clean your helmet with petroleum products, solvents,
benzene, thinner or cleaning agents.
DO NOT paint over your helmet's finish without totally protecting
and isolating the shock-absorbing liner and plastic parts.
Your warranty will otherwise be invalidated.
DO NOT drop your helmet from any height onto a hard surface.
This could cause damage to your helmet's finished and/or
decrease its ability to protect you.
DO NOT place your helmet on your motorcycle's rearview mirror:
The sharp pressure from the mirror's edge will compress and
damage the helmet's shock-absorbing liner.
DO NOT place your helmet on the motorcycle's seat or fuel tank.
It can easily roll off and hit the ground causing damage to the
helmet. It is best to place your helmet on the ground so it cannot
fall in any direction.
DO NOT modify any part of your helmet, e.g., drilling the shell or
cutting and pressing the shock absorbing liner. Installation of
sound systems, speakers and microphones reduces your
helmet's ability to protect you and is not recommended.
DO NOT use the helmet again if it has either been dropped or
involved in an accident. Replace it even if the damage is not
visible to the naked eye.
DO NOT place your headliners and cheek pads in the dryer after
washing. Allow them to air dry.
DO NOT use paint which requires heat curing.
Warranty
Should you have a warranty claim, go to your Scorpion dealer with
your invoice (this is you purchase proof, it's necessary in order to start
the warranty process).
You can find our dealers' list on your website: http://www.scorpionsports.eu
/english/dealers/find-a-dealer/find-a-dealer.html (choose your country and
then the location)
The dealer will contact our after sales service and start the warranty process
in order to check and/or repair your helmet.
EN
6