cam S2300 Manual De Instrucciones página 10

INSTRUCTIONS fOR USE
IMPORTANT: Keep tHese
instructions for future
IMPORTANT: reaD carefullY tHese instructions Before usinG tHe HiGHcHair.
the safety of your child could be at risk if you do not follow these instructions. wARNING!
never leave your child unattended. wARNING! the harness must be used at all times.
always ensure the harness is fitted and assembled correctly prior to use. wARNING! only
use the highchair when all parts are fitted and adjusted correctly. wARNING! never use
the highchair in close proximity of an open fire or any other source of heat, or electricity
supply. IMPORTANT: cam il mondo del bambino s.p.a. reserves the right to make any
necessary changes to the product at any time for commercial or technical reasons.
IMPORTANT: this product must be used for the means it was designed for. any misuse
and the manufacturer declines all responsibility. do not use replacement parts that are not
recommended or supplied by cam il mondo del bambino s.p.a., as these non-approved
parts may render the highchair unsafe. IMPORTANT: do not use the highchair if any parts
are missing, broken or mis shaped. IMPORTANT: do not use the highchair if any parts
are not fitted and adjusted in the correct way. wARNING! do not use this highchair until
the child is able to remain in the seated position unaided. wARNING! never use the
highchair without seat padding supplied by the producer.
ASSEMBLING ThE hIGhChAIR
this highchair has been packed in a very compact way. remove the highchair from its carton and
remove the protective film (fig 1.1).remove all components (fig 1.2). Before assembling be sure
to assemble all loose parts as described.
OPENING ThE hIGhChAIR: lower the small fixed tray (fiG.2.2) by simoultaneously widening both
sides (fiG. 2.1). to fit the larger tray, pull back on the lever under the front of the tray (part.a),
position onto the small fixed tray (fiG.3.1) and slide on. (fiG.3.2). the tray can be fitted in 5 different
positions. from behind the highchair, grip the low lever "X" and pull it upwards (fiG.4.1). the
highchair will open automatically. (fiG. 4.2.). the frame will "click" into place when locked. Make sure
that the locks are fully engaged before placing your child in the highchair (fiG. 4.3) wARNING: part
"H" is a safety component (part. B).
fITTING ThE BASkET: fit the basket onto the frame , by means of the webbing on each corner of
the basket. slide the webbing on to the hooks on each corner of the frame, see (fig.5.1) and (fig 5.2).
fITTING ThE 5 POINT hARNESS AND ThE SEAT PADDING: fit straps "a" into the upper slots of
the seat padding, followed by the straps of waist harness "B". attach to the buckle as illustrated
in fig 6. fit the crotch strap into the seat padding and attach to buckle "c". fit the seat padding
onto the seat unit first at the base of the seat unit and then onto the backrest. for your child's
comfort the harness can be adjusted to suit.
INSTRUCTIONS
ADjUSTING ThE hEIGhT: to lower the highchair in to any of the 6 positions operate lever "Y",
positioned at the rear of the backrest (fig 7). lever "Y" is only to be used when lowering the seat.
ATTENTION: to raise the highchair simply pull up on the top edge of the highchair seat unit.
ADjUSTING ThE BACkREST AND ThE fOOTREST: operate lever "X" positioned on the rear of the
highchair backrest (fiG. 8). the backrest and the footrest adjust simultaneously transforming the
09
reference.