Publicidad
Idiomas disponibles
Idiomas disponibles
10
CAUTION:
26. Choose a name panel #5 on either side of the table and install
one safety latch #8 into the right-hand hole on that name panel
as shown in Figures 8 & 9. Use one screw #10 one washer
#17 and one hex nut #16. NOTE: Flange on safety latch
must extend over top of name panel as shown in Figure 8.
Safety latch must pivot freely.
27. Go to the other side of the table and install the second safety latch
into the right-hand hole on the other name panel #5.
Safety latches must be attached diagonally across
from each other See Figure 9.
.
Figure 3
Figure 9
Figure 3
8
INSTALL SAFETY LATCHES #8 AS SHOWN ABOVE FOR PROPER USE OF
TABLE! DO NOT SKIP THIS STEP! DO NOT OPERATE TABLE UNTIL SAFETY
LATCHES ARE INSTALLED AND ASSEMBLY IS COMPLETE!
NOTE:
10
Figure 8
Figure 3
Figure 3
Publicidad
