Ninja BL492 Instrucciones página 14

Assembly and Use of the Blend & Prep Bowl - cont.
USE
CHOPPING BLADE
ASSEMBLY
Fig. 1
USING THE CHOPPING BLADE ASSEMBLY
1
Review warning and caution statements on page 12 before
proceeding to number 2.
2
Place the motor base on a clean, dry, level surface such as a
counter or table top. Press down on the motor base to make
sure that the suction cups adhere to the counter or table top.
3 Secure the bowl onto the motor base.
4 Holding the Chopping Blade Assembly by the shaft, place it
onto the gear shaft inside the bowl. Ensure that the Chopping
Blade Assembly fits around the gear shaft and that it is
standing straight. (Fig. 1)
5
Add the ingredients and secure the bowl lid onto the bowl.
6
Plug the power cord into the electrical outlet. Once the bowl
is engaged, the programs available for that attachment will
illuminate. Select the program desired based on your recipe.
The Auto-iQ program will stop the appliance automatically
™
at the end of the program.
7 When you have reached your desired consistency, stop
the appliance by pressing the STOP/START button or by
selecting the program twice. Wait for the Chopping Blade
Assembly to stop turning. (Fig. 2)
8
To remove the lid, press the release button on the lid and pull
the lid handle up to a 90° angle. (Fig. 2)
9
Turn the bowl counter-clockwise and lift it to remove it from
the motor base. (Fig. 3)
10 To release the motor base from the counter or table top, place
your hands underneath both sides of the motor base and
gently pull the unit up and towards you. (Fig. 4)
13 1-877-646-5288
REMOVAL
Fig. 2 Fig. 3
Fig. 4
USING THE DOUGH BLADE ASSEMBLY
IMPORTANT: This makes 1 Lb. of dough at a time. Do not
overfill or exceed. Motor may overheat.
1
Review warning and caution statements on page 12 before
proceeding to number 2.
2 Place the motor base on a clean, dry, level surface such as a
counter or table top. Press down on the motor base to make
sure that the suction cups adhere to the counter or table top.
3
Secure the bowl onto the motor base.
4
Holding the Dough Blade Assembly by the shaft, place it onto
the gear shaft inside the bowl. Ensure that the Dough Blade
Assembly fits around the gear shaft and that it is standing
straight. (Fig. 5)
5
Add the ingredients and secure the bowl lid onto the bowl.
6 Plug the power cord into the electrical outlet. Press the
START/STOP button to turn on the unit. Once the Bowl is
engaged, the programs available for that attachment will
illuminate. Select LOW on the control panel and process
until ingredients come together to form a mass.
7 Once finished making the dough, stop the appliance by
pressing the STOP/START button or by selecting the
program twice. Wait for the Dough Blade Assembly to stop
turning.
8
To remove the lid, press the release button on the lid and pull
the lid handle up to a 90° angle. (Fig. 2)
9
Turn the bowl counter-clockwise and lift it to remove it from
the motor base. (Fig. 3)
10 To release the motor base from the counter or table top, place
your hands underneath both sides of the motor base and
gently pull the unit up and towards you. (Fig. 4)
USE
DOUGH BLADE
ASSEMBLY
Fig. 5