Powersaver; Checklist - Samsung SyncMaster 152B Manual De Instrucciones

PowerSaver

This monitor has a built-in power management system called PowerSaver. This system saves energy by
switching your monitor into a low-power mode when it has not been used for a certain amount of time. The
monitor automatically returns to normal operation when you move the computer's mouse or press a key on
the keyboard. For energy conservation, turn your monitor OFF when it is not needed, or when leaving it
unattended for long periods. The PowerSaver system operates with a VESA DPMS compliant video card
installed in your computer.
Use a software utility installed on your computer to set up this feature.
SyncMaster 152B/152S
State Normal Operation
Power Indicator Green
Power Consumption
Less than 30W
SyncMaster 172B
State Normal Operation
Power Indicator Green
Power Consumption Less than 38W
This monitor is EPA ENERGY STAR
when used with a computer equipped with VESA DPMS functionality.
®
As an ENERGY STAR Partner, SAMSUNG has determined that this product
meets the ENERGY STAR
26
Power saving mode
Power Switch off
EPA/ENERGY 2000
Green, Blinking Black
Less than 2W Less than 2W
Power saving mode
Power Switch off
EPA/ENERGY 2000
Green, Blinking Black
Less than 2W Less than 1W
®
compliant and ENERGY2000 compliant
®
guidelines for energy efficiency.
Troubleshooting
Before calling for service, check the information in this section to see if you can remedy any
problems yourself. If you do need assistance, please call the phone number on the warranty card,
the phone number on the Information section or contact your dealer.
Check List
Symptom Check List
No images on the screen. Is the power cord connected
I cannot turn on the monitor. properly?
Can you see "No Connection,
Check Signal Cable" on the screen?
If the power is on, reboot the
computer to see the initial
screen(the login screen),
which can be seen.
Can you see "Video mode not
supported" on the screen?
There is no image on the screen.
Is the power indicator on the
monitor blinking at 1 second
intervals?
I cannot see the On Screen Have you locked the On Screen
Display(OSD). Display (OSD) Menu to prevent
changes?
27
Solution
Check the power cord connection
and supply.
Check the signal cable connection.
If the initial screen (the login screen)
appears, boot the computer in the
applicable mode (the safe mode for
Windows ME/2000/XP) and then
change the frequency of the video card.
(Refer to the Preset Display Modes)
Note: If the initial screen (the login
screen) does not appear, contact a
service center or your dealer.
You can see this message when the
signal from the video card exceeds the
maximum resolution and frequency that
the monitor can properly handle.
Adjust the maximum resolution and
frequency that the monitor can properly
handle.
The monitor is in PowerSave mode.
Press a key on the keyboard or move
the mouse to activate the monitor and
restore the image on the screen.
Unlock the OSD by pressing the
MENU button for at least 5 seconds.