Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
4 INSTALLATION
-
Remove 2 screws from the bottom of thermostat. Gently pull the control panel straight off the base.
Forcing or prying on the thermostat will cause damage to the unit.
-
Connect wires beneath terminal screws on power supply module using appropriate wiring schematic.
See figure 2.
-
Push power base into 86mm×86mm conduit box.
-
Using two mounting screws mount the power base to the wall. Place a level against bottom of base,
adjust until level, and then tighten screws. (Levelling is for appearance only and will not affect ther-
mostat operation.).
-
Replace control panel on the power base and fix power base and control panel by removed two
screws in item.
5 WIRING DIAGRAM
DIGITAL FANCOIL THERMOSTAT
Figure 2
KTFD-01
27 / 34
Publicidad
Tabla de contenido
