Using Your Dvd Player - Insignia NS-M10OHD Guia

9 Attach the DVD player to the metal mounting
plate using the CM 4
×
Four CM4 8 screws
10 Reconnect the battery.
Note
• Remember to connect the red wire to the
ignition switch (ACC), or the vehicle's battery
might be drained.
• If the fuse is blown, make sure that the cables
have not caused a short circuit, then replace
the old fuse with a new one of the same rating.
• Do not allow unconnected cables or terminals
touch the metal on the vehicle or any other
conducting material. Thoroughly wrap exposed
wiring with electrician's tape or use wire caps.
• To prevent short circuits, do not remove the
caps from unused terminals or from the ends of
the unconnected cables.
• After the player is installed, make sure that the
brake lights, blinkers, wipers, and other devices
on the vehicle are working correctly.

Using your DVD player

Opening and closing the DVD player
To open and close the DVD player:
1 Press the Open button to unlock the LCD
panel.
Open button
× 8 screws.
www.insignia-products.com
2 Swing the LCD panel downward to the
desired angle.
Caution
The LCD panel opens to a maximum angle of
150°. Do not try to open it farther.
150°
3 To close the player, swing the LCD panel
upward until you hear the lock click.
Warning
For safety of the vehicle occupants, close the LCD
panel when it is not in use.
Caution
Make sure that cords and other items do not get
caught in the panel when you close it.
Using the remote control
Installing the remote control battery
Before using the remote control, you must install
the included battery.
To install the battery:
1 Slide the battery holder to the right (as
shown) while at the same time pulling it away
from the remote control.
2 Place the battery with the (+) side up in the
battery holder. (Use battery type CRD2025.)
7