Start Up Guide; (2.2) Usage - Snooper MY-TRAK SPT220 Guia Del Usuario

2. Start Up Guide

2.1 Startup
2.1.1 Insert a Valid GSM SIM card into the "SIM Card" slot on the left hand side of
the SPT220. Please use the tool provided to push the SIM card into the slot.
2.1.2 Place the SPT220 in an open area and press and hold the POWER button for 2
seconds to start the SPT220.
2.1.3 Within approximately 30 seconds the unit should connect to the GSM
network. When the SPT220 has connected to the GSM network, the GSM indicator
light will flash brightly every second. Whilst searching for the GSM network the
indicator light will flash faintly once a second until the GSM signal has been
established.
2.1.4 Whilst the device is establishing connection with the GSM network it will also
begin to establish connection with GPS. Whilst the unit is searching for GPS, the
GPS indicator light will flash once once every second. Once the unit has connected
to the GPS signal the GPS indicator light will illuminate permanently.
2.1.5 When the unit has connected to both GPS and GSM the unit is ready to track.
2.2 Usage
2.2.1 Setting Authorized Users
After you purchase the SPT220, you should set the authorized user(s) immediately.
It also can be used with no authorized users set.
To set: Insert the SIM card into a mobile phone and set four numbers as Contacts,
in the Phonebook. Save these numbers to the SIM card (not the mobile phone's
memory). If you save more than four Contacts, the SPT220 will identify the first four
numbers as authorized users.
5