SILESTONE Integrity Guia De Instalacion página 13

3. Cleaning the parts to be bonded.
You must clean the two parts to be bonded (the worktop
and the edge of the sink) with solvent or alcohol before
applying the silicone. Otherwise, the silicone will mix with
any residue left on these parts, making the worktop and
sink not completely sealed and resulting in a joint with a
different colour than that of the worktop and sink.
Area to be cleaned
Area to be cleaned
Area to be cleaned
Installation manual Integrity by Silestone®
2
4. Applying ColorSil.
Apply silicone to the edge of the sink. Use COLORSIL
silicone in the same colour as the sink (included in the
package) and the worktop.
Area to be cleaned
5. Reinforcement anchorage kits (see
the last two pages of this manual).
6. Reinforcing the worktop.
In order to prevent breakage of the worktop and to
reinforce it, fix a wooden baton to the wall, the distance
between the units, on the underside of the worktop.
Countertop
Sink
Reinforcement block
13