SILESTONE Integrity Guia De Instalacion página 14

Installation manual Integrity by Silestone®
2
Instructions for the manual installation of the
integrated sink.
Cosentino does not recommend carrying out this type of installation
if you do not have the right tools or the necessary skills. In this case, use the first option.
1. Making the sink cut-out in the
worktop.
The worktop cut-out should be 3mm smaller than the
interior size of the sink, although this will depend on the
technician's criteria, as the smaller the flange, the less
you will have to polish it.
2. Creating a recess for the worktop
cut-out.
A 23mm wide recess should be made around the cut-out,
so that 5mm of the material is left on the surface of the
worktop.
14
Sink/washbasin size
Open hole
Lowering
23mm
5mm
Open hole
3. Cleaning the parts to be bonded.
You must clean the two parts to be bonded (the worktop
and the edge of the sink) with solvent or alcohol before
applying the silicone. Otherwise, the silicone will mix with
any residue left on these parts, making the worktop and
sink not completely sealed and resulting in a joint with a
different colour than that of the worktop and sink.
Zona a limpiar
Zona a limpiar