SILESTONE Integrity Guia De Instalacion página 16

Installation manual Integrity by Silestone®
2
Instructions for the manual installation of the mitred
sink.
Cosentino does not recommend carrying out this type of installation if you
do not have the right tools or the necessary skills. In this case, use the first
option.
You can order the Integrity sink model with the mitred joint edge. If you have
any questions, please contact your local COSENTINO Center.
1. Making the sink cut-out in the
worktop.
The worktop cut-out must be 2mm less on each side than
the dimensions according to the template supplied with
the sink.
2. Making the mitre.
The machining of the cut-out perimeter and the sink must
be carried out using a CNC. A suitable set of diamond
grinding wheels must be used to perform the mitre cut.
16
Sink size
Open hole
3. Cleaning the parts to be bonded.
You must clean the two parts to be bonded (the worktop
and the edge of the sink) with solvent or alcohol before
applying the silicone. Otherwise, the silicone will mix with
any residue left on these parts, making the worktop and
sink not completely sealed and resulting in a joint with a
different colour than that of the worktop and sink.
Area to be cleaned
4. Applying SoluMastik.
Apply the SoluMastik on the cut-out mitred joint.
Area to be cleaned